The steps below are shortened from the Vauxhall TIS pages for the Speedster. The VX220 shares the same engines and most of the car, but check anything unusual against your own car. The TIS pictures and the full wording aren't reproduced, so use the workshop manual if you are doing the job. We haven't seen owners' accounts of this job, so there are no owner tips here.
Small trim jobs from the TIS. The front liners also come up when you are taking the undertray off; see Undertrays: removing and refitting.
Badges
The TIS steps are the same for the Turbo and the NA.
Procedure
- Remove badge from rear clamshell (Pull off)
- Install badge to rear clamshell (Push fit)
Load compartment mat
The TIS steps are the same for the Turbo and the NA.
Install
- Mat from load compartment – release from velcro fastening.
- Mat to load compartment – attach to velcro fastening.
Front wheel arch liner
The TIS steps are the same for the Turbo and the NA.
Procedure
- Liner, Front Wheelarch, Remove and Install
Remove, Disconnect
- Wheel - bolts.
- For liner on right side only, remove from front compartment:
- - tyre inflator aerosol - release from clips
- - fuse box - 2 screws
- - relay box - 2 screws.
- Liner - 6 screws.
Install, Connect
- Liner - 6 screws.
- For liner on right side only, install to front compartment:
- - relay box - 2 screws
- - fuse box - 2 screws
- - tyre inflator aerosol - engage in clips.
- Wheel - bolts 90 Nm.
Rear wheel arch liner
The TIS steps are the same for the Turbo and the NA.
Liner, Rear Wheelarch, Remove and Install
- Left side shown, right side similar.
- Wheel - bolts.
- Liner - 6 screws.
Install, Connect
- Liner - 6 screws.
- Wheel - bolts 90 Nm.